PDA

View Full Version : WTB 1984 Mustang SVO heater / ac controls



Larry_S
10-14-2012, 06:06 PM
Looking for good condition heater control panel. Not sure what years are the same but my car has factory AC. The one I have has broken pieces on back side and does not work well. Looking for a good panel that works well and is not broken up on front or back.

Patrick
10-14-2012, 09:13 PM
The fan switch is available online or at your local parts store.

SVOC
10-15-2012, 06:32 AM
Pat you notice he said the pieces that are on the back are broken, this is what holes the switch to the HVAC panel, the problem with these breaking is becoming more and more of an issue.


Larry, when I get back from Nashville I will look in my stash to see if I have a good one, BTW verify, it does have a rear window defrost also?

Larry_S
10-15-2012, 07:15 AM
It does have a rear window defrost. The biggest issue without looking at it as I am at work is I think the plastic assembly the vacuum lines connect to is broken. I think it mounts to the back and one of the mounts is broken causing it not to be flush against panel backplate. Also control that select AC/ heat/vent is not working well an intermittent although now thinking about it that is probably due to mentioned issue with vacuum assembly being broken on back of panel.

Patrick
10-15-2012, 02:11 PM
Pat you notice he said the pieces that are on the back are broken ...

Aha! There are several operating out there with JB Weld where there once were broken tabs.

tommyb
10-17-2012, 07:52 PM
I know I have this I will locate it and take some pictures this weekend

Larry_S
10-18-2012, 05:27 AM
Sounds good can you email pics to 1761

SVOC
10-26-2012, 03:00 PM
The switch will need to JB Weld in the typical spot where the retaining pin was/is

https://sphotos-b.xx.fbcdn.net/hphotos-prn1/59472_10152217709515529_218721701_n.jpg

Bottom part is cracked and broken

https://sphotos-a.xx.fbcdn.net/hphotos-prn1/553690_10152217709000529_1445704889_n.jpg

Larry_S
11-08-2012, 08:20 PM
Still looking for one of these. SVOC pm a price or email to 1836

Larry_S
11-17-2012, 09:53 PM
Thanks tommyb! Drove the car to town today and the heat worked with the control assembly you sent. Thanks again!

tommyb
11-22-2012, 08:10 AM
Thanks tommyb! Drove the car to town today and the heat worked with the control assembly you sent. Thanks again!

Glad everything worked out Larry!!

RonJ
01-06-2013, 08:36 AM
You can also put a small hole there and use a small sheet metal screw works very well.