View Full Version : Hatch striker size
brsvo
11-11-2012, 03:02 PM
I need to make a new bushing for my hatch striker does any one know the OD of the original?
Patrick
11-12-2012, 05:57 PM
.6655"
brsvo
11-12-2012, 07:55 PM
Pat I remember a thread where you stated you made yours over size is that this dimention or actual stock? Thanks for the reply, Bruce
Patrick
11-12-2012, 10:10 PM
This is one that I made. I have made them from delrin, which is more durable than nylon, and shrinks a miniscule amount after machining on a lathe. You can check out a new one in the help section of the local auto parts store. They sell the whole assembly (bolt, washer, and bushing) for about $8.00.
brsvo
11-13-2012, 03:43 AM
I have found the doors but not the hatch. Besides I need winter projects!
MikeFleming
11-13-2012, 09:20 AM
Is wiring the lathe a winter project?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.