Oil Cooler to block gasket

[k98dave]

NPD has listed NOS oil cooler to block gasket in their catalog however they never really had any in stock.

http://www.npdlink.com/store/products/gasket_oil_cooler_original_e3zz_6l621_a-164980-2457.html


Late Model shows what looks like the same gasket under the 4.6 motor oil cooler

http://www.latemodelrestoration.com/item/LRS-6621AA/1996-04-Mustang-Oil-Cooler-To-Adapter-Gasket-For-46L-4V

Is this later gasket ok to use on our oil cooler?

Thanks

[Meotchh]

no, the later gasket is different it will not work.

I believe I still have a couple of the correct gaskets in stock if you want one.

[k98dave]

Yes I will take one. Also the head should be here tomorrow, looks like some shipments were delayed with all that wild cold air & snow.

[Meotchh]

I'm still in Vegas, so I'll get back to you by Friday.

[Meotchh]

Dave,

I checked on the O-rings & unfortunately I am out at this time. I'll check with my supplier & follow up with you when I have an ETA.

[SVOJames]

Dave,

I've got a few of the correct gaskets/O-rings, I can part with one to help a fellow TX SVO owner. :)

Do you still need one?

[k98dave]

Thanks guys, I had to get the FelPro block gasket set and it has one in it. P/N of the set is CS8471-1

[Meotchh]

Are you sure that is the correct square o-ring? Last I checked, the felpro kit did not have the oil cooler to block o-ring.

[k98dave]

Yep its the orange colored square seal. Looks just like the old one.

[MikeFleming]

Grabber Orange??