dagenham
09-01-2014, 03:53 PM
If this is in the wrong place I'm sorry, I wasnt sure if it should go under suspension or brakes.
I am trying to remove the axles, the bolt going through the pin between the axles broke off. It is not tight and I can spin it freely but then I get to a point where I can no longer grab hold of it to turn it the rest of the way out. It is still in about a 1/4".
Does anyone have any ideas on how to spin it out the rest of the way??? I cant go straight in because of the bearing caps, and the bolt is so small and hardened that I cant drill it or even put a slot in it with a chisel to use a small screwdriver.
I am trying to remove the axles, the bolt going through the pin between the axles broke off. It is not tight and I can spin it freely but then I get to a point where I can no longer grab hold of it to turn it the rest of the way out. It is still in about a 1/4".
Does anyone have any ideas on how to spin it out the rest of the way??? I cant go straight in because of the bearing caps, and the bolt is so small and hardened that I cant drill it or even put a slot in it with a chisel to use a small screwdriver.