Size of the nut for the ground on the turbo?

[ChrisCurtin]

Hi,

Another missing part ...

Anyone know what size the nut is that attaches the O2 ground to the turbo (T3)? I tried a handful of nuts I had and none fit. Looks like a fine, but not sure what size.

Thanks,

Chris

[MikeFleming]

Not sure of the thread size - would need to check. It's probably a 6x1.00mm, if I were to WAG is. The stock one uses a 10mm hex head with a captive flat washer on it, iirc.

[DaveS]

Mike is correct, 6mmx1.00. Just checked the one on my car with a thread gauge, then ran a tap through the attaching nut. It does have a captive flat washer on it.

[ChrisCurtin]

Thanks guys!

[MikeFleming]

I WAS RIGHT!! I WAS RIGHT!

( Someone please make a note of this and remind me later. )

[Sick Puppy]

Mike, you were right two days ago...remember? :stick_poke: