Beta Test Dash Wire Harness Retainer Clips

[Desert Patina]

Hello,

I've put the dash clips up on Shapeways in beta. It will be printed in scintillated nylon, and is quite durable. It will have some stepping (the curves won't be perfectly smooth) and it will be a bit rougher than the originals.

I'm not sure if the originals were injected nylon or acrylic (my guess is nylon).

If you find something to fix, I'll send you one of the fixed ones for free.

Q-Clip...
https://www.shapeways.com/product/CESP6E6QD

D-Clip...
https://www.shapeways.com/product/4M49TBQ6E

And I found this while I was there ...

https://www.shapeways.com/product/LXBDWUFKP/84-86-ford-mustang-svo-bi-wing-support

[ChrisCurtin]

First link doesn't work.

Last one is N20Capri (on FEP, TF and maybe on here?)

[Desert Patina]

Does this link work? (They work for me, so I can't say for sure what is still not working)

https://www.shapeways.com/product/CESP6E6QD/82-86-mustang-dash-wire-harness-retainer-q-clip

[ChrisCurtin]

Does this link work? (They work for me, so I can't say for sure what is still not working)

https://www.shapeways.com/product/CESP6E6QD/82-86-mustang-dash-wire-harness-retainer-q-clip

Tried again this morning and I'm getting their 404 page.

[Desert Patina]

Thanks for checking. I'll call them to see what is going on. When it does show up, it will show up there, and also here...

https://www.shapeways.com/shops/aellm

[Chalky]

All we need now is outer marker and headlight lenses and we'll be good to go!!!!