Cam recommendations?

[green57]

Gents,

Looks like I found a crack free head so looks like the head job can begin (phrasing). With the upgraded turbo, ported E6, 3 inch down pipe, LA3 with 35# injectors, square intake, and a port and polish job on the head. I'd like to up grade my cam. I'm trying to get to 250 maybe 300 hp. I don't want to go over board as it is my daily driver.

I was going to go with a Boport 1.5, but that is not an option anymore.

I was given a recommendation for the Crane 194621 h 272-2 cam. I have read some reviews on that cam and most think it is not a good selection for a turbo motor.

What seems to be a good cam to fit what I'm trying to do?

For those that have a set up similar to mine, what cams are you running?

Thanks for any recommendations.

G57

[Under Pressure]

I have similar setup I went with a Engle 55H best cam I've run. Real nice street cam with good power pulls good from 2700 rpm strong 3k up. It pulls strong past 6k. I have it set at zero. I haven't dialed it in or dynoed it, been busy with other projects.