PDA

View Full Version : Source for aluminum drive shaft


majestic
03-17-2021, 10:47 AM
Can't seem to find one in stock anywhere. Looks like I need part number
M-4602-G
But everything I can find is for a 31 spline unit instead of the 28 spline. Anybody have a source for this?
Mike S
03-17-2021, 01:21 PM
You can get one here: https://www.jegs.com/i/JEGS/555/60640/10002/-1
majestic
03-17-2021, 04:48 PM
You can get one here: https://www.jegs.com/i/JEGS/555/60640/10002/-1

Ordered, thanks!
majestic
07-18-2021, 12:45 PM
Finally received this about a week ago. It is about 1/2 inch shorter than the stock unit. Will that cause any issues with the transmission engaging that much less? Or should I install some washers at the differential to make up the difference?
MikeFleming
07-18-2021, 03:51 PM
Should be 45.5 inches center-to-center of the U-joints.

As long as there is 3+ inches of engagement into the gearbox output splines, you're good to go.

BTW - measure engagement depth with the rear diff at normal ride height - it moves in/out as the diff goes up/down.

DO NOT add washers to the space between the diff flange and the driveshaft. It MUST be centered on the diff lip.
majestic
07-19-2021, 07:32 AM
Should be 45.5 inches center-to-center of the U-joints.

As long as there is 3+ inches of engagement into the gearbox output splines, you're good to go.

BTW - measure engagement depth with the rear diff at normal ride height - it moves in/out as the diff goes up/down.

DO NOT add washers to the space between the diff flange and the driveshaft. It MUST be centered on the diff lip.

Thanks, Mike. It does measure 45.5. Just surprised at the difference between the stock and this one.
majestic
08-24-2021, 09:37 AM
Getting a grinding noise on deceleration while in gear and if you "lug" it. No issues when accelerating hard and at higher rpms. I guess we might throw the stock drive shaft back in and see if it goes away. Anyone else run into this with the aluminum unit?
MikeFleming
08-24-2021, 06:51 PM
That is a very common noise at low RPMs in a 4-cylinder. The aluminum shaft echo's the noise where the factory steel one has a yuuuge damper at the front.

Solutions I've had success with are to replace the pilot needle bearing and get the gearbox mainshaft endplay within spec (spec is +/- 0.0020").