View Full Version : starter solenoid wiring
Keasbey
05-30-2012, 10:43 AM
Does anybody would be kind enough to take a picture of their starter solenoid? I'm just confused on what wire goes where?
thanks
MikeFleming
05-30-2012, 02:32 PM
A couple installed pics. The rear-most stud goes to the large cable that goes directly to the starter motor. The front large post gets the alternator charging cable and the battery positive cable. The push-on small screw stud gets the ignition cable start wire (two red wires together).
MAKE SURE the case of the solenoid has a good ground to the fender panel.
796
797
( And No, the battery is no longer mounted with tire wraps. That was a test fitting. )
Keasbey
05-30-2012, 02:39 PM
( And No, the battery is no longer mounted with tire wraps. That was a test fitting. )
Yeah thats what they're all sayin'... lol
I have an extra yellow wire and a "greenishh/brownisshh " wire that I'm sure they were going there.. but I don't remember what stud they were bolted to?
MikeFleming
05-30-2012, 02:59 PM
Photographic evidence.
798
799
( And I'm sticking with that story. )
Keasbey
05-30-2012, 03:16 PM
Wow, thats one heck of a clean svo.. wish mine could be that clean!! hehe
MikeFleming
05-30-2012, 06:02 PM
^
I abhor fingerprints.
Jay4hand
05-31-2012, 05:58 PM
Photographic evidence.
798
799
( And I'm sticking with that story. )
Where did you get that battery and tray? Can you tell me about it or provide a link?
MikeFleming
05-31-2012, 06:07 PM
That's an Odessey PC-680 - weighs in about 14-16 Lbs, depending on which model (normal, armored, more, etc.) with SAE terminals. Common in snowmobiles, mortorcyckles, ski-do'es, etc.
The bracket is one I found for that battery on the Internet (have specifics somewhere) that I had powder-coated in gloss black. It's a dry cell battery. Also available in a deep-cycle version.
http://www.odysseybatteries.com/battery/pc680.htm
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.