LC2 Wideband Install help

Printable View

07-19-2016, 03:28 PM
Humango

LC2 Wideband Install help

I need help with the LC2 I'm installing in my 84. Does anyone know which wire on the headlight switch I should tap into to dim my gauge when the headlights are turned on?
07-20-2016, 08:07 AM
Humango

1 Attachment(s)

Switch Diagram

Here is the switch diagram

Attachment 9050
07-20-2016, 11:31 AM
Humango

Well I just got off the phone with an Innovate tech and was told that I should use the headlight wire (H) to connect the gauges yellow dimmer wire to, because when the gauge sees 12 volts on the yellow dimmer wire it will dim.
07-27-2016, 09:44 AM
SchoolBoy

Good to know, since I still need to do this as well. Where in the exhaust did ya put sensor?
07-27-2016, 10:34 AM
MikeFleming

Note that the SVO has a nine (9) pin headlight switch and associated harness. Foglight circuit.

AFAIK the other cables/colors remain unchanged - but you should verify that.

All times are GMT -8. The time now is 01:49 AM.

Copyright Notice: This website and its contents are copyrighted by www.svocop.com - © SVO Club Of Pat, 1991-2020. All rights reserved. Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following: 1) You may print or download to a local hard disk extracts for your personal and non-commercial use only 2) You may copy the content to individual third parties for their personal use, but only if you acknowledge www.svocop.com as the source of the material You may not, except with our express written permission, distribute or commercially exploit the content. Nor may you transmit it or store it in any other website or other form of electronic retrieval system.