Search:

Posting this for a guy locally. Here is the ad link. http://desmoines.craigslist.org/

......

Get a hold of SVPU. They make new header panels and adjuster brackets. There is a several week wait time for it to be produced but the quality is top notch and some of the weak points are corrected....

No good ones. I sold the car around a month ago. Hopefully the new owner finds his way over to the board.

http://i741.photobucket.com/albums/xx53/86svo9l/SVO/0720122300.jpg

Good luck on the wire tuck! It took me about 2 weeks to finish. It always looks like a simple process until you start repairing the bad, moving, extending, figuring out where to mount stuff so it can...

They will replace it completely.

http://i741.photobucket.com/albums/xx53/86svo9l/SVO/0720122300b.jpg

Well several weeks back I ended up selling the car. I mentioned this site to the new owner, he has owned a SVO in the past so maybe he will make his way on over. I on the other hand went over to the...

You can either plumb one in on the inlet of the turbo, kind of like how the stock setup was by drilling and tapping a hole with the compressor cover off. Or you can pick up a MBC for fairly cheap and...

http://www.svocop.com/forum/showthread.php?668-SN95-Throttle-Body-upgrade

Not sure when they started to come with them. Mine was built in October of 85 if I remember correctly and had an E3.

Thanks! The white has really grown on me over the years.

They fit just fine. A little rubbing out back, but nothing a rolled fender will not fix.

You will enjoy it. Power is more linear and comes on smoother, at least in my case. I have the .68 exhaust so I don't hit full boost until 3800. I am sure with the lower AR you will see boost sooner....

Thanks! I have went through a few different exhaust systems and this is my favorite so it gets to stay.

Quick clip of my car.


http://youtu.be/lWISYKg67no

Heres a clip of my car.


http://youtu.be/lWISYKg67no

The older ignition switches like to do this. When I was a broke HS kid driving a 79 notch I used to use a small screw to hold the switch just forward enough for the car to run but not engage the...

Looks better than most SVO's I have seen, a new set of headlights and markers can go a long way in the looks department. Plus you are using it for its purpose. Good luck on all the upgrades and don't...

Sounds like an adventure! Time to get some new calipers and get that thing back on the track, most likely that caliper along with a few other issues could be causing the bad braking. The rear...

Beautiful car!

Same here, ground them out. Also when I did mine I opened the outlet up to match the gasket instead of the sideways D shape and contoured and removed material to unrestrict the #4 and #3 ports. If...

Next up will be the 72lb injectors, Quarterhorse and Aeromotive fuel pump that have been far to cozy in my garage cabinets.

A couple updates. Cracked header caused me to get angry at the car. Spent that anger time porting out a spare E6, not a ton of time into it, only about 6 hours. It seems to have done the trick. Car...

Thanks!

It has been a long road. Its in a good spot right now so I am just kind of enjoying the car for the summer when its nice before doing much else to it. So there may or may not be any...

Looks like your keeping good progress.

I know there is a lot of hate against the flowmasters, but I run a 3" downpipe into a 3" midpipe, from there it goes into a better flowing split and into a flowmaster catback. It has a nice mellow...