Thank you both for the clarifying question - yes it was the castle nut and the answer of 45 ft-lbs.
Type: Posts; User: rasmith9; Keyword(s):
Thank you both for the clarifying question - yes it was the castle nut and the answer of 45 ft-lbs.
Might anyone have the torque specifications for the spindle nuts on the lower ball joint? I replaced the dust boots and searched here and the internet and found one site that stated "150#" (assuming...
Thought it'd be good to advise that the smell (more like Engine bay smell than a leak in the exhaust) went away with the install of the new firewall to hood seal. Thanks again for the help!
Thanks for your response, I was able to locate some and am good to go.
Thought I'd reach out here first, looking for headlights in excellent condition.
Thanks Pat, point noted on the search.
Explanations appreciated - I have enough to move forward now - will use the soldering iron and heat shrink options on the cut wires.
That's got to be it! I will check it out and reply. Probably a day or two because rains coming.
Not sure, how should I check? Is there a hole or a rubber seal?
ok, why is c-h-e-v-y changing to poopy.....not saying that I don't like it!
I replaced the front springs last weekend and noted that the dust boots on my ball joints were bad. I thought I remember someone replacing the dust boots with those from a poopy truck or something...
I posted this on another website, some of you may have seen a while back - I haven't had much time to work on the SVO lately and have just finished a couple fixes and now have it very driveable....
OK, I feel like a complete idiot when approaching anything electrical.....can you tell me if this makes any sense at all, two scenarios one for each schematic:
First Schematic
1. red wires on the...
I purchased an electrical relay from Pat several years back that increases the brightness of the headlights. I left it sitting in my garage while fixing up the car and am ready to install the...