Results 1 to 4 of 4

Thread: Sun Visors

  1. #1
    Some Boost
    Join Date
    Oct 2012
    Location
    Fort Worth TX
    Posts
    366

    Sun Visors

    OK I just installed all new interior (carpet, dash pad, headliner & trim) along with new visor rods but passenger side visor will not stay up against the roof and drops down every few minutes Is there any way to fix this? If there a metal tube inside the visor that can be squeezed down to make it hold?

    Thanks

  2. #2
    Half Boost
    Join Date
    May 2012
    Location
    Duncannon PA
    Posts
    521
    IIRC there is a small set screw. I would look at mine but a PO put '91 or newer ones in my car.

  3. #3
    Some Boost
    Join Date
    Oct 2012
    Location
    Fort Worth TX
    Posts
    366
    The visors are original as I could not find correct replacements. I'll have to check for a set screw, where is it? under the vinyl?

  4. #4
    Half Boost
    Join Date
    May 2012
    Location
    Duncannon PA
    Posts
    521
    Now that I think about it you may be right. I was thinking of the nut on the end of the rod that goes up into the roof to adust the tightness of the whole rod.
    You may have to squeeze the sun visor itsself.
    Hopefully someone else will chime in and confirm this.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •