E Brake brake bracket

[Ford Builder]

Am looking for picture of the E brake cable support bracket at the rear end getting my car back together after four years and am missing these brackets help ?

[MikeFleming]

"at the rear" as in the bracket that attaches to the rear axle housing?

I have those somewhere.

At the top is the bracket that holds the flex-to-hard line brace.

Next comes the bracket that holds the end of the parking brake cable to the axle housing. It attaches with two self-threading Torx screws. On top of that is the piece that the rear shock lower mounts to. it has a bent ear that goes through the center hole in the parking brake cable bracket through another hle in the axle housing flange, and a single stud that goes through the bottom of the axle flange.

Img_6667.jpg
Img_6670.jpg
Img_6684.jpg

Note that that stock rear shock mount is only strong enough to mount the shock and handle the damping forces - it is NOT strong enough to support the weight of the rear of the car as is needed when using coil-overs. Or friends at MM supply a bracket in their CO kits that is much thicker and uses two bolts to mount the lower shock mount to hte axle flange for CO installations.

Here's some shots of my merging of the lower shock mount and the SVO brake cable mount.

Img_1952.jpg
Img_1953.jpg

Not to worry - they were PC'd gloss black before installation.

[svopony]

Img_1952.jpg
Img_1953.jpg

Not to worry - they were PC'd gloss black before installation.

that has got to be a first Mike is using gloss black instead of "RED"

[Ford Builder]

I would like to thank you Mike & Svopony for the pictures , I need to buy a set of brackets or make them , they have got lost at the basters, I need them ASAP so it can hit the road.

[svopony]

I just copied the pics of Mikes so I give him the credit.


Bar

[Ford Builder]

Mike your THANKED ~!!

[MikeFleming]

Party On, Wayne!