Results 1 to 2 of 2

Thread: Instant center

  1. #1
    Half Boost
    Join Date
    May 2012
    Location
    Oconomowoc, WI
    Posts
    972

    Instant center

    I have recently installed my new Wild Rides torque box. It has many options for upper connection points. What if any changes would I want to make to improve IC or Anti squat/anti dive? I tried corner carvers but my email won't let me register. Which way from stock would make an improvement if any? Keeping in mind I am running the poor mans 3 link and a watts.

  2. #2
    Building Boost Bob, get off my lap! Jack Hidley's Avatar
    Join Date
    Dec 2012
    Location
    Danville, CA
    Posts
    65
    You need to put the car on a drive on lift, then take very careful measurements of the fore/aft and up/down measurements of the RLCA and UCA pivot points. Take these relative to the ground plane for the height and relative to the rear axle centerline for the fore/aft. Also document the ride height by measuring from the top of the fender arch to the ground, in the front and rear.
    Jack Hidley
    Maximum Motorsports Tech Support

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •